RainSoft Ultrefiner II Owner's Manual download pdf (Page 19)

• AUTOMATIC DRAIN SHUT-OFF VALVE • pH RANGE: 2 - 11

• MANUAL FAST FLUSH VALVE • REPLACEMENT FILTERS:

• DAILY PRODUCTION RATE = 16.02 GPD

DESCRIPTION ITEM#

• EFFICIENCY RATING

= 17.54% PRE FILTER 51635

• RECOVERY RATING

= 37.23% MEMBRANE 51637

• MAX TDS LEVEL (PPM) = 1400 POST VOC FILTER 51636

• CAPACITY FOR VOC REDUCTION: 225 GALLONS

• OPERATING PSI OF SUPPLY: 40 - 100 PSI (275 - 689 kPa)

• OPERATING TEMPERATURE: 50 - 100

F (10 - 38

PERFORMANCE DATA SHEET - page 1 of 3

Ultrefiner II - FMV

PREMIUM DRINKING WATER SYSTEM

THE UNIT SHOULD BE INSTALLED IN AN AREA NOT AFFECTED BY

EXTREME HEAT, COLD, OR THE ELEMENTS. THIS SYSTEM MUST BE

INSTALLED IN ACCORDANCE WITH ALL APPLICABLE STATE AND LOCAL

LAWS AND REGULATIONS.

DO NOT USE WITH WATER THAT IS MICROBIOLOGICALLY UNSAFE OR

OF UNKNOWN QUALITY WITHOUT ADEQUATE DISINFECTION BEFORE

OR AFTER THE SYSTEM. SYSTEMS CERTIFIED FOR CYST REDUCTION

MAY BE USED ON DISINFECTED WATER THAT MAY CONTAIN FILTER-

ABLE CYSTS. THE SYSTEM CONTAINS REPLACEMENT COMPONENTS

CRITICAL FOR EFFECTIVE REDUCTION OF contaminant. THE WATER

SHOULD BE TESTED PERIODICALLY (2 TIMES A YEAR MINIMUM) TO

VERIFY THAT THE SYSTEM IS PERFORMING SATISFACTORILY.

REPLACE ULTREFINER II - FMV MEMBRANE CARTRIDGE 24 TO 36

MONTHS AFTER INSTALLATION, DEPENDING ON WATER CONDITIONS.

A WATER TEST FOR TDS REDUCTION IS THE BEST INDICATOR OF

MEMBRANE PERFORMANCE. REPLACE THE PREFILTER AND POST FIL-

TER CARTRIDGES 12 MONTHS AFTER INSTALLATION OR SOONER

DEPENDING ON WATER CONDITIONS.

THE INLET FEED WATER SHOULD BE FREE FROM IRON, MANGANESE,

SULFUR.

NSF CERTIFIED PERFORMANCE DATA, AS SHOWN ON THE

PERFORMANCE DATA SHEET, IS BASED ON OPERATION AT DRAIN

SETTING # 2. CERTIFICATION RESULTS DO NOT APPLY TO OTHER

SETTINGS.

SEE WARRANTY CARD FOR SPECIFIC WARRANTY INFORMATION

NOT APPROVED FOR USE IN CALIFORNIA. PLEASE REQUEST

CALIFORNIA-SPECIFIC LITERATURE FROM YOUR LOCAL RAIN-

SOFT DEALER.

LIST OF contaminant

CONTAMINANT

AVERAGE

INFLUENT

CONCENTRATION

(mg/L)

AVERAGE

EFFLUENT

CONCENTRATION

(mg/L)

AVERAGE PERCENT

REDUCTION

MAXIMUM

EFFLUENT

CONCENTRATION

(mg/L)

ARSENIC

0.29 0.002 99.3 0.003

BARIUM 9.5 0.14 98.5 0.35

CADMIUM 0.031 0.0006 98.1 0.0011

CHROMIUM

(HEXAVALENT)

0.3 0.007 97.7 0.013

CHROMIUM

(TRIVALENT)

0.31 0.003 99.0 0.006

COPPER 3.0 0.038 98.7 0.069

CYST 26000 5 >99.99 21

FLUORIDE 8.6 0.39 95.5 0.51

LEAD 0.16 0.003 98.1 0.019

NITRATE/NITRITE

32 4.2 87 5.2

RADIUM 226/228 25 pCi/L 5 pCi/L 80 5 pCi/L

SELENIUM 0.1 <0.006 >94.0 <0.006

TDS 750 27 96.4 86

TURBIDITY 11 NTU 0.08 NTU 99.3 0.26 NTU

NSF/ANSI STANDARD 58 TEST CONDITION: 50 ± 3 psi, pH 7.5 ± 0.5, 77 ± 2 ºF

IMPORTANT NOTICE:

READ THIS PERFORMANCE DATA SHEET AND COMPARE

THE CAPABILITIES OF THIS UNIT WITH YOUR ACTUAL

WATER TREATMENT NEEDS. IT IS RECOMMENDED THAT

BEFORE PURCHASING A WATER TREATMENT UNIT, YOU

HAVE YOUR WATER SUPPLY TESTED TO DETERMINE

YOUR ACTUAL WATER TREATMENT NEEDS.

Model ULTREFINER II - FMV - BNFP, ULTRE-

FINER II - FMV - BNFV, ULTREFINER II - FMV

- CHFP and ULTREFINER II - FMV - CHFV are

tested and certified by NSF International

against NSF/ANSI 58 for the reduction of

claims specified on the performance data

sheet.

This system has been tested according to NSF/ANSI 58 for reduction of the

substances listed below. The concentration of the indicated substances in

water entering the system was reduced to a concentration less than or

equal to the permissible limit for water leaving the system, as specified in

NSF/ANSI 58.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Comments to this Manuals

No comments

RainSoft Ultrefiner II Owner's Manual Page 19

Comments to this Manuals