RainSoft QRS SERIES Specifications download pdf (Page 9)

System Start Up

1. Turn on the Water and Check for Leaks

• Close all faucets that were opened in Step 5 of the Installation

Instructions.

• Turn the water back on at the meter or pressure tank.

• Check for leaks. If a leak is present, drain the plumbing again

before soldering.

2. Flush the System

• Open a cold water faucet and allow water to run for a few minutes

or until all foreign material from the installation is washed out;

close the faucet.

• Slowly move the bypass valve handles to the service position. The

bypass valve handles should be parallel to the pipes.

• Allow water to completely fill the tank.

• To purge any air trapped in the system, open a cold water faucet

and allow water to run for at least 2 minutes; close the faucet.

• To flush any remaining hard water from the hot water heater, run

hot water in the bathtub until cold; close the faucet.

The installation is complete and the system is ready for use.

Maintenance Requirements

Replacing the Filter Media

The filter media will eventually become exhausted or consumed and

will need to be replaced. RainSoft replacement filter media (part

number 51501) is available through your local RainSoft Dealer. If you

are unable to order replacement parts from your local RainSoft Dealer,

please contact RainSoft at 1-800-860-7638 for assistance.

Helpful Tip: We recommend replacing

the filter media every three years (or

earlier if necessary). Your local RainSoft

Dealer can give you specific replacement

schedules based on your water usage

and incoming water quality.

Carbon Filter

Anti-Scale

Line IN

Line OUT

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

RainSoft QRS SERIES Specifications Page 9